Ratings
If your facility has switchgear marked 115,000 volts that is surplus or scheduled for decommissioning, you can share the visible rating and other safely accessible details for a cash offer. A rating is useful identification, not a promise of fit or purchase. Offers depend on the equipment and the information available; not every item is accepted. You do not need to test it or arrange site work to ask us to consider it.
Share the visible rating
A safely taken photograph of the exterior nameplate can help identify equipment marked 115,000 volts. You may also type the rating exactly as printed, including punctuation, units, and any nearby voltage-class wording. Keep the photograph to labels and exterior surfaces you can reach without opening equipment or entering a restricted area; do not move covers or approach energized gear to get a better image.
If the nameplate is obscured, damaged, or not safely accessible, say so rather than trying to uncover it. A clear description of the label’s location, equipment type, and visible manufacturer name can still provide context. Brand names identify equipment only; they do not establish an affiliation, condition, acceptance, or compatibility. You can share what is already known without preparing an inventory or performing site work.
Rating versus system voltage
A facility’s nominal system voltage describes the intended designation of the electrical system. The marked equipment rating is a separate nameplate value assigned to the equipment. Those figures may differ because a nameplate can state a rated maximum, a class, or another manufacturer-defined designation rather than repeat the site’s nominal voltage. A 115,000-volt mark should therefore be reported as printed, not interpreted as proof of the connected system voltage.
For example, records might describe a system by a nominal voltage while the visible nameplate uses a different rated value or voltage-class notation. Share both figures if they are already documented, labeling each source: for instance, “nameplate says 115,000 volts” and “facility record lists nominal system voltage.” Do not infer one value from the other or use either to claim the equipment suits a particular application.
Keep electrical work qualified
Switchgear may be energized or retain hazardous energy even when a facility is shut down. Do not open equipment, remove panels, operate controls, isolate circuits, or disconnect conductors to confirm a rating or prepare the gear for review. Electrical evaluation, switching, isolation, and disconnection must be handled by qualified personnel under the facility’s applicable safety procedures.
Your part can remain limited to information already available and exterior photographs that are safe to take. If a label cannot be viewed without entering a hazardous area or touching equipment, leave it alone and tell us the detail is unavailable. We do not require the seller to test the equipment. Unknown condition or missing information can be stated plainly; guessing at internal condition or electrical status is unnecessary.
What helps assess an offer
Along with the visible 115,000-volt marking, useful known details may include equipment type, approximate quantity, general condition as observed from outside, and whether the gear is surplus or part of a planned decommissioning. Existing records can help distinguish a single lineup from associated equipment, but creating a new inventory is not a prerequisite. Be clear when a detail comes from a record rather than a current inspection.
If available, mention other exterior nameplate information such as a manufacturer, serial number, or additional ratings exactly as shown. Voltage and current are different measurements: do not describe an amp rating as a voltage rating or assume a value that is not legible. Photos are optional and should only be taken from a safe, accessible position. Missing data may limit assessment, but it does not require you to perform electrical work or testing.
Purchase and site logistics
We make cash offers and pay upfront for equipment we agree to buy. Offers depend on the specific equipment and available details, and not every item is accepted. If we buy the equipment, we handle and pay for the crane, rigging, disconnection through qualified personnel, loading, freight, and hauling. The seller has no responsibility to arrange, perform, or pay for that physical work.
You do not need to test the switchgear, disconnect it, hire a separate contractor, load it, or arrange transportation as a condition of having it considered. Any required electrical work is performed through qualified personnel; you should not carry it out yourself. The offer and purchase decision are specific to the equipment under consideration, so a marked 115,000-volt rating alone does not guarantee acceptance or establish suitability for another system.

